LOCTITE EA 9395 AERO Epoxy Paste Adhesive QUART
LOCTITE EA 9395 AERO is a two-component adhesive system, which cures at ambient temperature and has excellent strength properties @ 350°F/177°C and higher. This product is thixotropic and is ideal for potting, filling and fairing applications. LOCTITE EA 9395 AERO does not contain metallic filler and can be used with composite substrates. It is ideal for applications where RAM/RAS considerations are important.
- Non-Metallic Filler
- Cures at Ambient Temperature
- Excellent Mechanical Properties
- Good Compressive Strength
Mixing – This product requires mixing two components together just prior to application to the parts to be bonded. Complete mixing is necessary. The temperature of the separate components prior to mixing is not critical, but should be close to room temperature (77°F/25°C).
Mixing – Combine Part A and Part B in the correct ratio and mix thoroughly. THIS IS IMPORTANT! Heat buildup during or after mixing is normal. Do not mix quantities greater than 450 grams as dangerous heat buildup can occur causing uncontrolled decomposition of the mixed adhesive. TOXIC FUMES CAN OCCUR, RESULTING IN PERSONAL INJURY. Mixing smaller quantities will minimize the heat buildup.
Applying – Bonding surfaces should be clean, dry and properly prepared. For optimum surface preparation consult the LOCTITE Surface Preparation Guide. The bonded parts should be held in contact until the adhesive is set. Handling strength for this adhesive will occur in 24 hours @ 77°F/25°C, after which the support tooling or pressure used during cure may be removed. Since full bond strength has not yet been attained, load application should be small at this time.
Curing – This adhesive may be cured for 5 days
77°F/25°C or 1 hour 150°F/66°C to achieve normal performance.
2.45 lbs per EA